Arm & Hammer Diaper Pail Refill Rings: Setup and Odor Tips

By Baby Products & Accessories | Munchkin | Published: 2026-11-03

Category: 使い方ガイド

Learn how to install Arm & Hammer diaper pail refill rings correctly, avoid common mistakes, and keep odor under control with simple pail care steps.

Quick answer

To install an Arm & Hammer diaper pail refill ring, open the pail, drop the ring over the internal rim with the film tail facing out, pull the film down through the pail opening, and knot the end before closing the lid. Then empty and re-ring the pail before it overfills to keep odors contained.

Why ring orientation and film routing matter

A refill ring works only if the film feeds cleanly through the pail’s internal channel. If the ring sits crooked or the film twists, the pail won’t seal properly and smells escape even when the lid is closed. Take an extra second to seat the ring flat and keep the film tail centered as you pull it down.

When a ring is the better choice than refill bags

Refill rings are a continuous film that you cut and tie after each fill, while refill bags are pre-sized sleeves you swap out. Rings typically hold more diapers per pack and create a custom-length bag every time, but they require you to knot the film and thread it through the pail correctly. Bags are faster to change but can be less economical if you change them frequently. Choose rings if you want fewer changes and don’t mind a short setup routine.

Step-by-step: installing and maintaining your refill ring

Open the pail and remove the old ring: Lift the lid and take out the empty ring. Wipe the inside rim with a damp cloth to remove any residue. Common mistake: skipping the wipe leaves a film that prevents the new ring from sitting flat. A clean rim is the first checkpoint for a proper seal.
Seat the new ring on the internal rim: Place the ring so the film tail hangs toward the front of the pail and the ring lies flat. Press down gently around the edge. Checkpoint: the ring should not wobble or tilt. If the ring rocks, reseat it before threading the film.
Thread the film down through the pail: Pull the film tail down through the center opening until it reaches the bottom. Keep the film flat and untwisted. Common mistake: pulling too fast creates a twist that blocks diapers from dropping. A smooth, straight film path prevents jams.
Knot the bottom of the film: Tie a tight double knot at the very end of the film so diapers cannot slip out. Checkpoint: tug gently to confirm the knot holds. A loose knot is the most common cause of leaks.
Close the lid and test: Snap the lid shut and drop in one diaper to confirm it falls freely into the bag. If it catches, open the lid and re-thread the film. Takeaway: always test with a single diaper before regular use.
Empty and re-ring before overfilling: When the bag is about three-quarters full, cut the film above the diapers, tie off the bag, and remove it. Then pull down fresh film and knot the new end. Common mistake: waiting until the bag is packed tight makes the cut messy and can tear the film. Mark a fill line on the pail if you tend to overfill.

Product facts

Arm & Hammer™ Diaper Pail Refill Rings: Made with 7-layer film and lavender-scented; one pack holds up to 272 newborn diapers. The multi-layer film and scent help lock in odor, and the high capacity means fewer refill changes if you follow the steps below.
Arm & Hammer™ Diaper Pail Refill Rings