How to Use a Baby Safety Harness for Stress-Free Outings

Quick answer

A baby safety harness like the Brica® By-My-Side™ keeps your child secure in strollers, shopping carts, and high chairs. Follow these steps to attach, adjust, and use it correctly every time.

How to use a baby safety harness step by step

1. 1. Attach the harness to the seat: Wrap the harness straps around the back of the stroller, shopping cart, or high chair. Thread the straps through the designated slots or around the frame so the harness sits at your child's chest level. Clip the ends together securely. Common mistake: attaching the harness too low, which lets your child slide down or slip out. The harness should sit at armpit height, not at the waist.
2. 2. Place your child in the seat: Set your child in the seat and pull the harness forward over their shoulders. Make sure the straps lie flat and are not twisted. Common mistake: leaving slack in the straps because your child is fussy. A loose harness can allow your child to stand or lean out. Check that you can fit only two fingers between the strap and your child's chest.
3. 3. Adjust the fit and secure the buckle: Pull the adjustment straps to tighten the harness evenly on both sides. The buckle should click audibly when locked. Common mistake: forgetting to check the buckle after adjusting. A partially closed buckle can open during movement. Always tug the harness gently after buckling to confirm it is locked.
4. 4. Test the range of motion: Let your child sit naturally and see if they can wiggle too much or if the harness restricts breathing. The harness should allow arm and leg movement without letting your child lean forward more than a few inches. Common mistake: over-tightening, which can cause discomfort or breathing difficulty. If your child slumps or seems uncomfortable, loosen the straps slightly and re-check the height.
5. 5. Use only for seated positions: The harness is designed for strollers, shopping carts, and high chairs. Do not use it as a car seat restraint or for any standing or lying position. Common mistake: assuming the harness works for car seats. Car seats require a five-point harness built into the seat. Stick to the intended uses to keep your child safe.

Product facts

• Brica® By-My-Side™ Baby Safety Harness, Owl: The Brica® By-My-Side™ Baby Safety Harness in Owl design helps prevent slips and falls while providing comfort for your child. This means you can focus on your errands or meal without constantly adjusting or repositioning your child.